meshing the lower grille 2mz

1. m_cooke999 Frequent Poster Joined: Jul 2007 Bolton Posts: 528 Posi 1.1i East Coast 99'

   #1 22nd September 2007, 21:57

   right, 2moz im going to embark on an attempt to mesh my lower grille and fog light holes.... ive read the how to guide but wont cutting the existing grille leave a nasty finish? will i not need to smooth the cut marks ect...?
2. saxojoe17 Regular Poster Joined: Jun 2007 West Sussex Posts: 379

   #2 22nd September 2007, 22:46

   no i wont leave a crappy finish you take care wen doing it. i did mine and turned out find. the only prob is where the mesh makes the grille stick out more.
3. m_cooke999 Frequent Poster Joined: Jul 2007 Bolton Posts: 528 Posi 1.1i East Coast 99'

   #3 22nd September 2007, 23:04

   what do you mean? im on about meshing my lower grille here...
   
   ok so on a posi blue saxo, silver or black mesh? and should i leave the slats in or remove them? obv removing them will be a harder job and could fuk up the whole thing if i mess up
4. Jungle_Jimm Forum Section Moderator Joined: Jan 2004 Abingdon, Oxfordshire, United Kingdom (England) Posts: 5082 RX8, Cliosport 197

   #4 22nd September 2007, 23:24

   the slats arent solid by the way, the cross section of them is like a sideways U. this means you will have to fibreglass and fill the holes and then repaint it