Seats

28th November 2007, 09:42

Any tips on removing and putting new seats in they are clown ones that are coming out and vtr whats going it

28th November 2007, 10:08

the seats are pretty striaght forward to take out/re-fit.

you'll have 2 torx bolts on the door side, and 2 on the handbrake side.

for the handbrake slide, slide the seat forward to get the bolt at the back, then slide the seat back to get the front one, then the two on the drivers side are easy to see/get at.

should have no problems mate.

i can't remember the torx bit size required, i think it's either T20 or T25.

hope this helps

28th November 2007, 11:05

Thanks pal.

28th November 2007, 11:11

dont forget the airbag wire thing! do it with the car switched off as it might go off, i think. but thats the easy bit.

you might have to swap the wire connector over as mine was different, jus an easy bit of wiring tbh, just undo n redo with the new one, make sure its firmly in

28th November 2007, 11:16

the bit underneath is the seat belt tensener i took some out the other day the torx is like a T40, and really straight forward to do.

28th November 2007, 11:54

the bit you put ya ass on in with back seatjust slips out and the backrest bit has 2 bolts either side, think 10mm spanner should do, then pull em out