another torson bar thread!!

1. J-Reid Established Member Joined: Jan 2008 Posts: 2036

   #1 10th February 2008, 15:56

   Hi people .
   While the weathers nice and whilst ive got half term off , im planning on lowering my furio 40mm
   Just wondered if its hard to lower the torson bar never done one before ? Anyone had any problems doing it themselves or just any advise would be great !
   Thanks !
2. J-Reid Established Member Joined: Jan 2008 Posts: 2036

   #2 10th February 2008, 16:27

   ?????? anyone ???????
3. s3tre2003 Frequent Poster Joined: Jun 2007 St.Austell Posts: 972 Moonstine 206 GTI,Aegean Blue 206 GTI180, Citroen

   #3 10th February 2008, 16:36

   search mate..theirs guides on here and links to other sites
4. craiggaler L-plater Joined: Feb 2008 sunderland Posts: 36 1.polo 2.corsa sri 3.megane 4.mr2 5.subaru imp

   #4 10th February 2008, 17:08

   hi just done mine today it was a bit of a hassle it took me all day . the problem i had was all the parts were rusted together and hard to get off and the torsion bar was also rusted in. if you are going to give it ago make sure you have got plenty of wd40 and some freeze spray you can get it from halfords for about £3 it is very handy to have. also i tried using a slide hammer to get the torsion bar out and it was no good at all. try using a big mettle pole and a big hammer and bash it out. anyway good luck you will need it
5. J-Reid Established Member Joined: Jan 2008 Posts: 2036

   #5 10th February 2008, 18:08

   ive just read ur thread, looks like u had abit of trouble !
   hope i dont have that much of trouble, thanks for the advise !