Just a quickie i think, not many answers needed here.
Just connecting up the ECU for the single plug setup (3 plug may apply im unsure)
So far the adaptor loom is plugged into the VTS engine loom
Then from that there is the wiring that goes to the wideband display and lambda sensor- lambda is connected.
Then theres a plug with a yellow ruppery seal bit on the plug and the connection bit has a red end- where does this bit go?
As far as i can make out thats all there is to it connection wise aside from the small earth bit what ill locate somewhere aswel
Just connecting up the ECU for the single plug setup (3 plug may apply im unsure)
So far the adaptor loom is plugged into the VTS engine loom
Then from that there is the wiring that goes to the wideband display and lambda sensor- lambda is connected.
Then theres a plug with a yellow ruppery seal bit on the plug and the connection bit has a red end- where does this bit go?
As far as i can make out thats all there is to it connection wise aside from the small earth bit what ill locate somewhere aswel
