Help fitting Ibiza splitter

1. W2EEL L-plater Joined: Aug 2007 Stafford/Stoke/Manchester Posts: 63

   #1 24th February 2008, 16:26

   Hi guys, does anyone know of a guide or any advice on trying to fit the Seat Ibiza splitter to my rear bumper.
   
   I know it needs to be cut down slightly at the ends and in the middle slightly to allow it it bend... but thats it.
   
   
   Any help appreciated.
   
   Cheers
2. Predator_R32p Super Moderator Joined: Mar 2003 Durham (England) Posts: 37932 1. AX 2. Mk2 Saxo VTR 3. MK4 R32 DBP

   #2 24th February 2008, 16:40

   just whack it on with self tappers mate, id ue some tiger seal or something too then trim the ends off, also i think you may have to do this, notch out tringles so it oesnt kink up when you fit it
   
   
3. W2EEL L-plater Joined: Aug 2007 Stafford/Stoke/Manchester Posts: 63

   #3 24th February 2008, 16:45

   The splitter seems pretty strong. I'm not sure its the right part.
   
   Do you have a photo of yours?
4. Predator_R32p Super Moderator Joined: Mar 2003 Durham (England) Posts: 37932 1. AX 2. Mk2 Saxo VTR 3. MK4 R32 DBP

   #4 24th February 2008, 16:50

   i dont have one on mate although i was going to, that picture is off a long time ago, im sure if you just heat it up a bit it will start to bend a bit better
   
   get a picture up of it
5. W2EEL L-plater Joined: Aug 2007 Stafford/Stoke/Manchester Posts: 63

   #5 24th February 2008, 17:07

   ha ha, I'll see how it goes first! I've got a week off, so i should have managed it by then
6. Predator_R32p Super Moderator Joined: Mar 2003 Durham (England) Posts: 37932 1. AX 2. Mk2 Saxo VTR 3. MK4 R32 DBP

   #6 24th February 2008, 17:18

   yeah, but thats how people used to fi them self tappers nad some sealent and just bend iund and trim off