Newbie (Torx T40)

1. rozaladdd Established Member Joined: Mar 2008 Solihull Posts: 1487 Black/Orange Vtr

   #1 27th March 2008, 21:29

   Ok i am a newbie to saxo's and wanna lower the back so after reading loads on this site though seem's simple enough but when i come to do it the T40 was a bitch and its not budging at all and iv gt my springs brought allready for the front only going 35mm and i cant undo the T40 bolt its corroded ?
2. Ste Saxperience Post Whore Joined: Mar 2007 Yorkshire Posts: 5415 Saxo

   #2 27th March 2008, 23:31

   If the bolt is completely ruined, get another bolt. Then you can either cut a deep line into the bolt and unscrew it with a big screwdriver or drill it out.
   
   I fail doing both and the bolt wins.
3. Richie2104VTR Saxperience Forum Bum Joined: Oct 2006 Newcastle Upon Tyne Posts: 2770 VTARRRR/S

   #3 28th March 2008, 00:31

   Heat it up with blow torch or drill it out as said....
4. rozaladdd Established Member Joined: Mar 2008 Solihull Posts: 1487 Black/Orange Vtr

   #4 28th March 2008, 08:45

   okay thanks guys will try this