is this what i want?

1. liam_b Saxperience Forum Bum Joined: Jul 2006 paignton Posts: 3168 saxo

   #1 6th April 2008, 06:20

   well im changing my front hubs for vts hubs witch means i have to change lower arms' struts and the arb so is this what i want for the vts setup on my 1.1
   
   http://cgi.ebay.co.uk/ws/eBayISAPI.d...TODAY.m238.lVI
2. Mark51p Super Moderator Joined: Sep 2006 Wakefield Posts: 14427 Golf GT

   #2 6th April 2008, 09:05

   yes it is mate but imo id get them new from a somewhere like Andrew Pages as they are only about £15 each then you know that they are 100% ok
3. liam_b Saxperience Forum Bum Joined: Jul 2006 paignton Posts: 3168 saxo

   #3 7th April 2008, 00:36

   i fort it was 15 quid for just the drop links not the hole arb
4. willsy West Midlands Joined: Nov 2005 Nuneaton (West Mids) Posts: 13835 '64 Volvo V40 R’Design, '89 Ph1 309 GTi, ‘97 Mk1 S

   #4 7th April 2008, 01:36

   If you are just wanting to change over to 4 stud hubs (am i right in assuming that you have 3 stud at the moment with a mk1 1.1?) then you DO NOT need to go to the extent of changing the Anti roll bar or wishbones etc.
   
   The bottom half of the vts strut can be used on any saxo. If you're lucky and know what you're looking for you can pick up some for about £40 with the same bearing type already inserted to match the ends of your driveshafts.
   
   If this is the case then you WILL NOT have to replace any other parts.
   
   The above is the cheapest way to swap over. If however you do want to fit the VTS anti roll bar and wishbones aswel then these are an easy swap. All the necessary bolt holes for the VTS arb are already in the chassis of every saxo, and the wishbones are an easy swap too
5. liam_b Saxperience Forum Bum Joined: Jul 2006 paignton Posts: 3168 saxo

   #5 7th April 2008, 02:28

   thanks mate reped yh im changing from mk 1 1.1 3 stud to 4 stud. only reson is to upgrade my brakes as im putting vts engine in so is there any benefits changing to the vts wishbones and arb? if so what?