resticking badges.

  1. Established Member Joined: Jan 2008 Posts: 2036
    #1
    taken off my rear badges to t-cut them, but tryed sticking them back on with "no more nails"
    i did the job of sticking but it left a load of crap around the edge of the badge when it was pressed, so i took them off again n cleaned off the crap.
    what did you all use ??
  2. Saxperience Post Whore Joined: Feb 2008 Southampton Posts: 8188 Astra vxr with added boost
    #2
    i just broke my pins aswell, im going to buy new badges bud scrap yard FTW
  3. Established Member Joined: Oct 2006 Birmingham Posts: 2401 Subaru Impreza WRX
    #3
    number plate sticky pads stick on cut round stick to car job done
  4. Established Member Joined: Jan 2008 Posts: 2036
    #4
    Quote:
    Originally Posted by Mike_08 View Post
    number plate sticky pads stick on cut round stick to car job done
    oh good idea, never thought of those, cheers.
  5. Established Member Joined: Oct 2006 Birmingham Posts: 2401 Subaru Impreza WRX
    #5
    i used it from halfords. heat the back of the car up a lil 1st before you restick them should mack it stick better
  6. Saxperience Post Whore Joined: Nov 2007 Liverpool Posts: 8780 Seat Leon
    #6
    Superglue ftw
  7. Established Member Joined: Jan 2008 Posts: 2036
    #7
    nice one, i didnt no were 2 get them from so that was a double helper lol. REP lol
    started to piss it down, had to put seler tape over the holes so water doesnt run in lol.
  8. Established Member Joined: Jan 2008 Posts: 2036
    #8
    Quote:
    Originally Posted by MrHouston View Post
    Superglue ftw
    no dont want to use that incase i ever want to take them off again. itl leave a glue mark.
  9. Established Member Joined: Oct 2006 Birmingham Posts: 2401 Subaru Impreza WRX
    #9
    Quote:
    Originally Posted by MrHouston View Post
    Superglue ftw
    not good idea due to paint. dont be such a piky lol do it properly

    put some sealent round the pins inside the boot to for bit more water protection mate