need help fitting the BMC filter

1. bruza88 Infrequent Poster Joined: Jun 2007 London Posts: 219 Saxo WestCoast

   #1 8th August 2008, 13:13

   can sounds help me and tell me where i fit the aluminium hosing because i fort i knew where it went then i relized that it leaning on the exhaust mouting and didnt think that was a good way of keeping the air cold? its in my westcoast
   
   ive searched with no luck
   
   any help would be great
2. DaveyBoy Regular Poster Joined: Aug 2007 Erdington, Birmingham Posts: 442 Mk1 Possi Blue Vtr, slammed, White Rims, Leathers,

   #2 8th August 2008, 23:33

   anywhere so that it gets cold air mate. doesent really mater. if i were you, take out a fog light.
3. TU-Tuning Saxperience Hardcore! Joined: May 2006 Bristol Posts: 16575 JP4urio, 306 DTurbo SportShed

   #3 8th August 2008, 23:48

   Most people use the std air ram in the slam panel, if its a bmc it will suck in air anyway so that bits perfect.
   
   
   Fog light holes are good too, but make sure you put a sharp right angle in the pipe before it gets to the filter or you could destroy your engine if you hit a large puddle
4. immense Established Member Joined: Jan 2008 Northampton Posts: 2241 Citroën Saxo VTR

   #4 9th August 2008, 00:05

   Use the standard air filter intake. Don't have it at the bottom although it will take in more air, it'll also take in all the crap off the road and water.
5. bruza88 Infrequent Poster Joined: Jun 2007 London Posts: 219 Saxo WestCoast

   #5 9th August 2008, 11:52

   when i brought the car i didnt have that blasted bit, i have found a way thow, i am just worring the aluminium* pipe is too close to the engine exhaust bit?