Brown plug from loom

1. user_14757 Established Member Joined: Mar 2007 Middlesbrough Posts: 1186 mazda 3 mps

   #1 21st September 2008, 17:46

   where does it go into?
2. gd16 Frequent Poster Joined: Nov 2003 Tayside Posts: 893 S/c VT!?

   #2 21st September 2008, 18:27

   ummm....
   
   Bit more info may help.
   
   
   Is it the brown plug in the engine bay, behind the dash, behind the rear 3/4 panel, at the boot?
   
   How many wires does it have going into it?
   
   Can you read one of the ID numbers off of the wiring?
3. raunchz Saxperience Addict Joined: Jul 2005 Solihull / Bournemouth Posts: 14233 2015 Lapiz Blue Golf R

   #3 21st September 2008, 20:14

   possibly the brown plug that plugs onto the carbon cannister under the drivers side wing,just take your inside wheel arch out, and you'll see it under there.
4. user_4153 Frequent Poster Joined: Oct 2004 Cambs Posts: 630 Vts track car

   #4 21st September 2008, 20:23

   Identfying what part of the loom its on would be a good start
5. Rhea21 Frequent Poster Joined: Jun 2008 stoke on trent Posts: 649 now looking for a new car! NOT A CITROEN!

   #5 21st September 2008, 21:01

   ???????????
6. user_14757 Established Member Joined: Mar 2007 Middlesbrough Posts: 1186 mazda 3 mps

   #6 21st September 2008, 21:36

   sorry for lateness... got a pic of it there,
   its for a gti as ive just a engine change, its from near the tb
   its a 2pin plug
   
7. gd16 Frequent Poster Joined: Nov 2003 Tayside Posts: 893 S/c VT!?

   #7 22nd September 2008, 00:31

   Could be loads of things :?
   
   TPS and MAP sensors are 3 plug, so is the Vehicle speed sensor. Reverse light connector is white. Coolant temp is blue or green connector.
   
   Have you got the following connected;
   
   Knock Sensor, Manifold Heater, Air Temp Sensor.
   
   
   Best bet is to peel back some of the tape on the wires and get the number off one of the wires, then tape it back up afterwards.
8. gavbey Frequent Poster Joined: Mar 2007 perth Posts: 811 cammed saxo vts

   #8 22nd September 2008, 23:06

   im puting the engine in with dan. its from somewhere near the inlet manifold. (ie round the back of it.) its no where to be seen.
   
   any1 heard of flames and smoke comin out inlet manifold when trying to start?
   cheers
9. user_14757 Established Member Joined: Mar 2007 Middlesbrough Posts: 1186 mazda 3 mps

   #9 26th September 2008, 02:41

   figured it out gav, its not needed as its for the air con models in differant countrys