Hi guys which cams would be best for a 16v engine? out of 3 cams Catcams 708's, 764's or Newman Ph3's.
Which cams for a 16v engine
-
#1
-
#2708's IMO
But really not much difference between the 3 -
#3Thanks Danny 708's it is then
would they be ok for a throttle bodied set up or supercharger set up?
-
#4erm yes as far as im aware, im looking at bodies for mine with the 708's. not sure about supercharger though as i know cat cams do a specific set of cams for boost....
-
#5Danny is right, cams for boost are different to n/a ones. Well the lift and all that stuff.
708's/ph3's are the common ones for the valver engine, some good gains to be had, a nice spread of power and no need to up rate everything along the way. -
#6PH3s, I just happen to have some new ones for sale :O
-
#7well 708 or ph3 i think the 708's are abit more expensive though, correct if am wrong though,
andy -
#8708's will run fine with a supercharger.
QEP recommend them iirc -
#9CAT cams'boost' cams have a slightly shorter duration on the exhaust cam iirc to prevent any over lap and boost leak. But this is more of a concern with turbo setups running a lot of boost, rather than a supercharger which is only likely to be running 10psi at most.
If I had the oppertunity, i'd probably swap my boost cams for a set of 708's. -
#10Go for PH3's tbh - cheaper.