taking off vtr rear beam

1. denni Established Member Joined: Apr 2008 exmouth Posts: 1714 saxo furio mango

   #1 21st July 2009, 20:31

   is this all i have to do to take it off?
   
   undo 2 brake lines, disconnect the handbrake cables then undo the 4 nuts and bolts (2 under rear seats and 2 under boot lining)
   
   also what do i need to put it onto my furio??
   
   also i have braided hoses on my furio can i use these on the vtr beam?
2. Aron Saxperience Forum Bum Joined: Feb 2007 Nuneaton Posts: 3554 EP3 Civic

   #2 21st July 2009, 20:33

   thats all you do and you do not need anything addition to the beam and brakes
3. denni Established Member Joined: Apr 2008 exmouth Posts: 1714 saxo furio mango

   #3 21st July 2009, 20:36

   so if i take off just the rear beam i dont need anythin else to fit it to my furio??
4. Aron Saxperience Forum Bum Joined: Feb 2007 Nuneaton Posts: 3554 EP3 Civic

   #4 21st July 2009, 20:39

   that it mate
5. denni Established Member Joined: Apr 2008 exmouth Posts: 1714 saxo furio mango

   #5 21st July 2009, 20:41

   ok mate. just i was readin somewhere n they said i would need vtr hand break cable, break lines etc. but if it just simple take beam off and bolt onto mine thats sweet
6. Aron Saxperience Forum Bum Joined: Feb 2007 Nuneaton Posts: 3554 EP3 Civic

   #6 21st July 2009, 20:46

   if your taking the beam off the handbrake cables and brake lines will be attached to it
7. denni Established Member Joined: Apr 2008 exmouth Posts: 1714 saxo furio mango

   #7 21st July 2009, 21:46

   will my breaded hoses fit the vtr beam? and i just need the handbreak cable that is attached at the vtr beam
8. AlexBp West Midlands Joined: Dec 2007 West mids Posts: 23149 Supra,civic GL

   #8 21st July 2009, 22:28

   your braideds will fit yes
   
   and the cables just disconnect from the handbrake not the caliper lol
9. denni Established Member Joined: Apr 2008 exmouth Posts: 1714 saxo furio mango

   #9 22nd July 2009, 16:43

   ye just disconnect the handbreak and unbolt. then bolt onto mine connect breaks up and handbreak. job done??