fitting induction kit ?

3rd November 2009, 08:46

ive got a vtr 98 on a s plate its got the standard black top engine. ive just brought a induction kit and its got the hole for the breather but there is another pipe with wires comes out the top left hand side of the rocker cover,
can any 1 tel me what this 1 is and what it does, most of the kits ive seen only have ther 1 breather, if i need to keep this unknown pipe how can i make my kit fit this thanks in advance

3rd November 2009, 08:51

Can you get a picture and circle what you mean on paint? I am finding it hard to picture.

3rd November 2009, 08:54

just had a look, its some kind of sensor and it is just behind the distributer or on top

3rd November 2009, 08:55

javascript: the wire thats going across the black part of filter;

3rd November 2009, 08:58

I think you may mean the airflow sensor, in that case you will definetly need it, otherwise the car wont know what ratio of petrol to air to put in. This will cause idle problems, lumpy running, bad drivability etc

3rd November 2009, 09:02

thought it was is there any way i can get this to work with new induction kit there is no hole for it. i might try and put it where the breather should go and buy a small breather filter to put on rocker cover

3rd November 2009, 09:03

Quote:

Originally Posted by r33ryan

thought it was is there any way i can get this to work with new induction kit there is no hole for it. i might try and put it where the breather should go and buy a small breather filter to put on rocker cover

Get a breather filter anyway mate. And it should atttach to the throttle body, not the actual filter

3rd November 2009, 09:10

i ment put that sensor in the induction kit where the breather hole is on the kit cos there is no where else to put that sensor

3rd November 2009, 09:23

The induction kit shouldnt effect it, it should go into the throttle body. If you put a breather filter on the hole can just be blocked up.

Upload a picture please.