Important! : mk1 bmc problem

1. holdawayt Saxperience Post Whore Joined: Jan 2010 Stourbridge Posts: 7338 Nissan 200sx S14a

   #1 3rd February 2010, 14:25

   hi, i feel stupid asking about this but its causing a headache.
   I've got a 97 mk1 and the standard air box looks like this:
   
   
   
   i've got 3 pipes coming off the standard air box. when i stick the BMC on do i just stick a breather filter on the rocker cover breather pipe and leave the other two?
   
   also what do i do with the air temp sensor?
   
   tom
2. Cammy Established Member Joined: Jul 2009 Aberdeen Posts: 2211

   #2 3rd February 2010, 14:48

   Take off the whole air filter mate ( all of that black box) leaves you with your inlet manifold, put the bmc where you took out the black box (old air filter housing)
   
   insnt hard
3. Cammy Established Member Joined: Jul 2009 Aberdeen Posts: 2211

   #3 3rd February 2010, 14:51

   Re: breather filter, take off the pipe from the rocker cover that goes to the air filter (just the one pipe) and put it on where you took the pipe off, then clamp down the strap on the back of the breather filter on it
   
   writing from my phone so dunno if it makes any sence
4. holdawayt Saxperience Post Whore Joined: Jan 2010 Stourbridge Posts: 7338 Nissan 200sx S14a

   #4 3rd February 2010, 14:59

   lol done plenty of filter swaps i'm not a tool. just not seen one with this many pipes n crap coming off it. oh and the new bmc doesnt fit between the battery and the coil pack. Sweet! lol