VTR Interior Fitting Help!

  1. Regular Poster Joined: Jul 2009 Bristol/Gloucester Posts: 345 Mk1 Saxo Sx 1.1i Buck Blue (first car)
    #1
    Does anyone know how hard/easy it is to fit a VTR interior (new front and back seats and front and back door cards) into a standard 1.1 saxo SX??

    Desperate for some advice or a guide ect.

    Cheers.
  2. Saxperience Forum Bum Joined: Sep 2007 Darlington/Newcastle Posts: 2609 Saxo VTS / Twingo RS133
    #2
    look in the stickies at the guide for fitting a gti interior pretty much the same process and the removing doorcards one will help too.
  3. Saxperience Addict Joined: Jan 2008 west london Posts: 13810
    #3
    very easy. disconnect battery to unplug pretensioner plugs under both front seats]
    for t40 torx bolts on each corner of the front seats. the backrest of the rear seat has 2 13mm bolts in each corner which you can see from the boot. the base of the seats just fold up and pull out.

    front doorcard has a screw near where the dash is and a screw in the grap handle bit, then just unclips all the way around
  4. Regular Poster Joined: Jul 2009 Bristol/Gloucester Posts: 345 Mk1 Saxo Sx 1.1i Buck Blue (first car)
    #4
    Beautiful, Cheers guys! Much appreciated

    Does anyone know how to change the rear door cards though?
  5. Saxperience Addict Joined: Jan 2008 west london Posts: 13810
    #5
    there just clipped in. might need new clips at like 10p each. i think for the rears you have to remove the parcel shelf, and bit where the boot light is to get it off and a new one in. easier to do this with no back seats aswell

    also best getting new clips for the front doorcards at citroen aswell as they break so easy
  6. Regular Poster Joined: Jul 2009 Bristol/Gloucester Posts: 345 Mk1 Saxo Sx 1.1i Buck Blue (first car)
    #6
    Yeahhh i've taken my front ones off loads of times and alot of them clips have broken even when i replaced them.