i have just noticed that my saxo which was dropped 60mm is lower on the back drivers side and higher on the back passenger side
does any1 else have the same issue??
wonky car
-
#1
-
#2who ever lowered it hasn't put the tortion bar back at the same height.
-
#3do you know how they drop the torsion bar is it a case of 5 clicks both end or do they need to measure form the center of the hub??
-
#4if one side is lower than the other, then the WRONG method of lowering has been done.
Your stub pins/bearings won't last as long as they should. Mines been lowered by this method, before i knew there was 2 methods. 25k later, one side has play in it. Not the end of the world, but i'm going to have to look for another beam. Will be my 3rd one lol. -
#5its either you have mucked up or lowering it or you need a new beam mate
-
#6yes mine was like this 1 side just went to the top of the tyre and the other end went right down to just about the alloy am telling you looked daft was about a inch out first thing i done was get it sorted went to the garage told them what was wrong left it with them for 4 hours went back 80 quid lighter but the car looked so much better so now lowered 40mm all round
happy days
-
#7i hope it is a case of the garage that have lowered it wrong, but was on the phone to them today and they did mention that it could be the axle that has gone?? and they also mentioned a banging noise which me car does make only when i pull up onto me drive. but as it stands me cars not going anywhere just yet as its pissin out water from the bottom radiator pipe lol am not havin any luck with this car tbh lol