paiting question

  1. Established Member Joined: May 2008 north east Posts: 1415 2002 saxo vts
    #1
    hi thought id ask this question on here the question is mate i was spraying my grill last night with spray cans outside in back garden i primed it then flattened the primer down then i down 2 coats of colour and flattened each coat down with some 1500 grit paper then applied a thick coat of colour on and waited for it going tacky then thich coat of laquer... the out come of the finish was amazin looked like it was done with a spray gun the problem im getting is that i had few dust particuls in the finish and show up in the light thequestion is how do i gt rid of these do i flatten them out using like 1500 grit or 2000 and then polish it out and if i do go down that route can i polish them out by hand with some compound or can i spray it again some were ill not get that dust on like in a old tent in garden or summit i know its daft but that might stop dust and flys lol ????? any advice mate
  2. Saxperience Forum Bum Joined: Oct 2009 Middlesbrough/Coventry Posts: 3808 Megane 225
    #2
    Wet sand with 1500 then tcut it back up to a shine
  3. Established Member Joined: May 2008 north east Posts: 1415 2002 saxo vts
    #3
    cool mate ill give it a go tonight the shine looks mint the method i used like
  4. Infrequent Poster Joined: Feb 2010 tipton Posts: 248 saxo vtr mk2 51 plate 3.2 omega mv6 02 plate
    #4
    I do actually find i can get just as good results with rattle cans as a pro can with a spray gun,well on small things anyway.Normally i find the hycote cans are briliant