spoox upper engine mount

1. Mathias Saxperience Post Whore Joined: Mar 2008 Pembrokeshire Posts: 5598

   #1 20th July 2010, 23:44

   Fitting my spoox upper engine mount next to ecu, need some help from others who are using this
   
   basically, you have the arm which connects engine to the mount itself and then a long bolt which goes through the spoox mount and then is supposed to go through the arm also, however the bolt which spoox supply is twice the thickness of the hole in the arm and mount location, is it just a simple case of drilling the hole out bigger?
   
   thanks
2. vtr_chris90 Established Member Joined: Jun 2008 nuneaton Posts: 1796 LY R26

   #2 20th July 2010, 23:48

   yer you jst need to drill the hole out in the arm to 12mm i think it is as the standard engine mount is 10mm
   
   its a dead easy job to do, took me about 15 mins to do on my vtr, cause its alot eaiser to get the arm and mount off than the 16v that was soooo much effort lol
3. Mathias Saxperience Post Whore Joined: Mar 2008 Pembrokeshire Posts: 5598

   #3 20th July 2010, 23:56

   thanks mate, was hoping you'd reply to this, was planning to pm you but couldnt remember your user name, thanks again!!
4. vtr_chris90 Established Member Joined: Jun 2008 nuneaton Posts: 1796 LY R26

   #4 21st July 2010, 00:14

   lol haha its ok man, no worries