PAS problem

  1. Saxperience Forum Bum Joined: Mar 2006 Norwich Posts: 2823 Vectra sri 2.6 v6
    #1
    Right to start i had the front end of my furio lowered 3 months or so ago then a short while after came a squeeking noise when turning but i checked to see if the steering pipe was rubbing and it wasnt............ today i pulled into the petrol garage and got petrol and also discovered id lost all power steering fluid....... the pipe has rubbed through by the track rod (the metal pipe). Where will i find one of theses? im not worried if its new or secondhand aslo would it be the same on all models? Iv got a furio 16v'd. Thanks
  2. Saxperience Post Whore Joined: Aug 2009 ilkeston derbyshire Posts: 9823 C2 VTR stripped, 406hdi, clio 172
    #2
    slight difference between mk1 and mk2 but interchangeable. think the mk1 pipe gives a bit more clearance too
  3. Saxperience Forum Bum Joined: Mar 2006 Norwich Posts: 2823 Vectra sri 2.6 v6
    #3
    Iv just taken my split one off and sealed the hole and put a bit of rubber pipe round it tight with jubilee clips and its still blown it open again, guessing its due to the pressure.
  4. Newbie Joined: May 2010 Chesterfield Posts: 16 1.4 saxo furio
    #4
    I tried getting one from local motor factors, turns out it was a dealer part, i ended up going to scrappy paid £5

    Possible pug106 pipe will fit aswell not sure, but there very simular