Attempting to tighten Rear ARB

1. masetw Infrequent Poster Joined: Aug 2010 London Posts: 167 Citroen Saxo VTR 51 Plate Lowered By 40mm Team D

   #1 29th August 2010, 17:03

   So ive read a few things about Tightening the rear arb if im getting a clunk from the rear end which i am. I found this pic and wanna know where the M8 bolt and washers screw into? and how far can i actually screw it in without fucking it up completly?
   Cheers
   Mason
2. masetw Infrequent Poster Joined: Aug 2010 London Posts: 167 Citroen Saxo VTR 51 Plate Lowered By 40mm Team D

   #2 29th August 2010, 17:03

   
3. masetw Infrequent Poster Joined: Aug 2010 London Posts: 167 Citroen Saxo VTR 51 Plate Lowered By 40mm Team D

   #3 30th August 2010, 13:37

   bump . anyone?
4. benvts10 L-plater Joined: Aug 2010 Posts: 63

   #4 30th August 2010, 16:54

   the bolt goes through the end of that plate and into the leg itself. should wind in atleast a cm.
5. benvts10 L-plater Joined: Aug 2010 Posts: 63

   #5 30th August 2010, 16:56

   and theres a larger bolt that goes through the plate and into the end of the arb
6. Mochachino Saxperience Hardcore! Joined: Nov 2007 Guantanamo Bay Posts: 28700 oyster card

   #6 30th August 2010, 17:13

   If you tighten it up and theres still a clunk or it comes loose again easily then its most likley with your arb being loose it has worn awayand dosent sit flush. So youll need to weld a lil bit to make it bigger so it sit flush and dosent have any flex/or play to make it clunk and come loose again.