Best way to remove a VT Kit??

1. Cammy Established Member Joined: Jul 2009 Aberdeen Posts: 2211

   #1 7th September 2010, 22:25

   Right, spraying my VT kit, there's patches on the driver door I need to sort out aswell (primer showing through)
   
   wanting to take the whole VT kit off, the bumpers are no problem, it's just going about getting the pannels on the door and quaters/arches off
   
   there is no guide to this to keep clips intact etc, or is it best just to pull them off and get new clips?
2. user_35776 Established Member Joined: Jul 2009 Barnstaple Posts: 1666 Mk 6 zetec s

   #2 7th September 2010, 23:18

   Just pull the off and prise the tigerseal off if any on there
   it's alot easier to not worry about breaking the old clips and get new ones I found when I took mine off it had sealant on it so I pulled clips off and span the panel around so not to break it
3. craigy2703 Regular Poster Joined: Apr 2009 Posts: 272 citroen saxo vtr 2001

   #3 7th September 2010, 23:29

   some advise mate on my car mk2 vtr the rear quarter kits theres one clip which is actually a bolt and is bolted from the inside so u have to remove the rear door card
4. Cammy Established Member Joined: Jul 2009 Aberdeen Posts: 2211

   #4 8th September 2010, 00:03

   Agh, that's going to be a bitch to do then!
5. user_34297 Saxperience Addict Joined: May 2009 Somewhere in Bonnyland Posts: 10669 Super clean mk5 Golf Gti and 306 hdi

   #5 8th September 2010, 01:57

   Rip the shite out it and clip/TS back on
6. user_10418 Saxperience Addict Joined: Jun 2006 Wirral Posts: 13584 Wickerd red VTS MK2, Two tone VTS MK2,vvc Metro..

   #6 8th September 2010, 03:37

   Just pull the off or use trim tools.......
7. user_35776 Established Member Joined: Jul 2009 Barnstaple Posts: 1666 Mk 6 zetec s

   #7 8th September 2010, 06:39

   I think thy will only be booted on if the previous owner has done that coz I haven't hear of that before so unsure