Alloy Fitment.

1. choness2004 Regular Poster Joined: Aug 2010 Portsmouth Posts: 361 Honda Civic EG

   #1 20th September 2010, 16:47

   Does anyone know where I can find the fitment for my car? There are a few alloys that I am looking at but I don't know whether they would be ok or not.
   
   Also, if I was fitting alloys, would I have to upgrade my suspension or lower my car so they fit right?
   
   Thanks.
2. mechsman Frequent Poster Joined: Sep 2010 Bristol Posts: 906 Saxo 1.4i SX 3dr, 106 (engine swap under way), p

   #2 20th September 2010, 16:55

   If it's got 4 stud hubs (99.9% sure it will have) it's 4x108 fitment with somewhere between ET15 to ET18 offset the alloys should be fine.
   
   You can use spacers to bring wheels with a high offset (ET number) down to the correct offset to fit the car. e.g Ford wheels have the same 4x108 bolt pattern but normally have a higher offset ET30 ish. You can get hubcentric spacers to reduce the offset to ET15 to fit the saxo.

   1 user thanked this post: choness2004
3. choness2004 Regular Poster Joined: Aug 2010 Portsmouth Posts: 361 Honda Civic EG

   #3 20th September 2010, 17:08

   Thanks mate