Are these the right bolts for vtr alloys

1. raul0 Established Member Joined: Apr 2009 Lincolnshire Posts: 1112 Wicked Red Furio

   #1 29th September 2010, 21:58

   Hi just got these from citroen and was wondering if its the right bolt. He said there the later version bolts for vtr alloys.
   
   
   
   I see they have a washer on them but im not sure whether its right or not due to it curvin up a bit in the middle. Is this the right one or is it the tapered one.
2. user_36198 Saxperience Post Whore Joined: Aug 2009 ilkeston derbyshire Posts: 9823 C2 VTR stripped, 406hdi, clio 172

   #2 29th September 2010, 21:59

   they are the correct ones for later VTR wheels
3. raul0 Established Member Joined: Apr 2009 Lincolnshire Posts: 1112 Wicked Red Furio

   #3 29th September 2010, 22:01

   are they flat bolts with washers ?
4. user_36198 Saxperience Post Whore Joined: Aug 2009 ilkeston derbyshire Posts: 9823 C2 VTR stripped, 406hdi, clio 172

   #4 29th September 2010, 22:05

   yes but there are 2 types of flat bolts with washers, the ones you have (later type) and ones with a parallel shank (early ones). Early bolts will fit later wheels but not vice versa
5. raul0 Established Member Joined: Apr 2009 Lincolnshire Posts: 1112 Wicked Red Furio

   #5 29th September 2010, 22:10

   ok i see how will i know if i have later vtr alloys ? Ive bin outside and checked if it fits in and all i know is that it goes it the hole and sits in it. ???
6. user_36198 Saxperience Post Whore Joined: Aug 2009 ilkeston derbyshire Posts: 9823 C2 VTR stripped, 406hdi, clio 172

   #6 29th September 2010, 22:12

   if the bolts fit in your alloys properly then they are fine
7. raul0 Established Member Joined: Apr 2009 Lincolnshire Posts: 1112 Wicked Red Furio

   #7 29th September 2010, 22:14

   So if the bolts i have were wrong it proberly would'nt go into the hole.
8. raul0 Established Member Joined: Apr 2009 Lincolnshire Posts: 1112 Wicked Red Furio

   #8 29th September 2010, 23:06

   not sure if i have the right ones tbh. Went and checked it and the thread dosnt come up all the way to the back of the alloy. It comes up just short so i dont know if this is a problem.