Cut off pull cables..

1. char69lie Established Member Joined: Apr 2010 Norwich Posts: 1275 00 Silver 106GTi

   #1 27th February 2011, 20:36

   Just wondering if there is a guide on how/ where to fit these? ive done a search and found a few people who have them.. and pics of where they are but not a guide as such?
   
   Any help would be great!
   
   Btw i have one for fire extinguisher.. and one for battery cut off..
2. isle-of-mull Infrequent Poster Joined: Aug 2009 Posts: 127

   #2 27th February 2011, 21:51

   on the battery master switch, run a heavy cable from the positive side of the battery to one of the big poles on the switch and use the 2nd large poll for your main electrical feed. there should also be 4 small spade terminals, 2 at no1 and 2 at no2, on the 2 spade connecters at no1 goes your 3 ohm resistor and then to earth, on the other no1 connecter take a feed from the large pole for the main electrical feed. on the 2 no2 connectors one should be connected to your ignition switch and the other to your ignition coil. on some master switches there marked x and y i think. but not to sure which way they go.
3. isle-of-mull Infrequent Poster Joined: Aug 2009 Posts: 127

   #3 27th February 2011, 21:53

   then once thats fitted you can just connect your pull cord to the switch.
4. char69lie Established Member Joined: Apr 2010 Norwich Posts: 1275 00 Silver 106GTi

   #4 27th February 2011, 22:03

   Thanks mate! Sounds simple enough!
5. isle-of-mull Infrequent Poster Joined: Aug 2009 Posts: 127

   #5 27th February 2011, 22:12

   glad u can understand it cause im not very good at writing what im thinking.
6. char69lie Established Member Joined: Apr 2010 Norwich Posts: 1275 00 Silver 106GTi

   #6 27th February 2011, 22:15

   Aha I had a bit of an idea how it went just not 100% just got to find out how and where to mount the cables on the exterior