Help with lowered Beam

11th March 2011, 18:59

hi there just joint this very good saxo web site and just have a quick question about a saxo vts we have , i have replace the bearings on the beam at the back and it is now rubing a little bit when the kids are in the back is it posible that i have got the hight wrong . this there a setting that would help me fix this , alos is there a way of making the ride harded so it will take more wight , any help with this would be great .

thanks

C

11th March 2011, 19:19

Quote:

Originally Posted by superman1973

hi there just joint this very good saxo web site and just have a quick question about a saxo vts we have , i have replace the bearings on the beam at the back and it is now rubing a little bit when the kids are in the back is it posible that i have got the hight wrong . this there a setting that would help me fix this , alos is there a way of making the ride harded so it will take more wight , any help with this would be great .

thanks

C

harden the ride i would say uprated shocks mate

12th March 2011, 08:56

i take it from what you harden the ride i drop the swing arm more then put it back on , it has all ready got a full spax racing setup . i think a got it out when i put it back after fitting the bearings on the beam , thanks for your help

C

12th March 2011, 21:05

raise the rear torsion, it will sit alot higher but you could take more weight but its not advisable. Standard factory hight should be fine and not rub.

13th March 2011, 11:47

thanks for your help , i did that and it looks out of place now but the wheels are 17" and 8" wide , i think that is not helping. might have to change the wheels for 16" and i bit thinner

13th March 2011, 12:10

17" wheels will be the problem