leaking radiator!

  1. #1
    Sooo i was on my way to fast show and started over heating and i was leaking badly!
    so now im after a new rad would a vtr/vts one fit into my furio??
    also how is the best way to fit a new one any guides would be mint!!
  2. #2
    To bleed my car can I feel it with water then start it let all the air put then refit the cap?
  3. #3
    yes it will fit, the radiator is very easy to remove and replace and to bleed the radiator crack the bleed nipple on the right of the rad and top up the rad till it comes out of the bleed valve (when it comes out shut the valve off) then crack the next bleed valve open on the right side of the engine and top up the radiator fluid till it comes out of that valve then shut that off, finally open the valve on the left of the engine and top fluid up untill it comes out of there (if it don@t come out then blow down the expansion tank untill it starts to come out, shut the valve off, now run the car, put the heaters on full blowing hot air and wait till the heater is blowing hot air out, now wait for the fan to kick in and your away! if the heating doesn't get hot then bleed the system again. GOOD LUCK
  4. #4
    forgot to mention, also make sure your stat opens when the engine is at operating temperature by feeling both sides of the radiator pipes to make sure there both hot! after your all done keep and eye on the coolant level as it will go down when the stat opens
  5. #5
    Ok sweet only thing I'm looking for is the nipples