bigger rear ARB = need to chabge ARB end plates?

1. Igorbio Infrequent Poster Joined: Jul 2010 Moscow Posts: 145 Saxo VTS mk2

   #1 24th May 2011, 18:42

   if I go bigger rear ARB do I need to chabge ARB end plates? Or the older ones will fit?
2. Mochachino Saxperience Hardcore! Joined: Nov 2007 Guantanamo Bay Posts: 28700 oyster card

   #2 24th May 2011, 18:44

   New ones, I think, cant even remember.
   
   EDIT: What Willsy said.
3. willsy West Midlands Joined: Nov 2005 Nuneaton (West Mids) Posts: 13835 '64 Volvo V40 R’Design, '89 Ph1 309 GTi, ‘97 Mk1 S

   #3 24th May 2011, 18:56

   The end plates are the same. Although make sure that you have a matching pair as some have been found to have been cut differently on the internal splines causing the end plates not to match up correctly.
4. Gareth_R Established Member Joined: Mar 2010 Basildon, Essex Posts: 1042 Citroen AX VTS

   #4 24th May 2011, 22:23

   Some are different
   
   E.g I have a 14mm ax gt arb which uses much smaller splints section than the 22mm vt one. All Saco ones might be the same though
   
   Tbh, I swear you can't actually remove one of them?
5. Igorbio Infrequent Poster Joined: Jul 2010 Moscow Posts: 145 Saxo VTS mk2

   #5 25th May 2011, 08:17

   I am going from 19mm to 20mm