VTS mani on a VTR

1. logy55 L-plater Joined: May 2010 Mirfield, Huddersfield Posts: 34 Silver mk2 vtr

   #1 6th August 2011, 18:35

   My mani on my vtrs gone, bought a new downpipe and lamda sensor not so long back so thats fine but seen an original vts mani and downpipe on ebay. To my knowledge the only difference is its a form of 4-2-1. Ive searched but not seen anyone done this. My sax is a mk1 cat set up event hough its a mk2 (W reg) so cat is further back.
   Not looking at a raceland etc, got bills to pay, but i figure for the same money spent getting a vtr why not get a vts mani instead. Was just wondering if anyone, if so hows it gone and hows it done in term in performance?
   cheers
2. Vtr_Cam Frequent Poster Joined: May 2010 neath port talbot Posts: 984 Wicked Red VTR mk2

   #2 7th August 2011, 00:13

   VTS manifolds dont fit VTRs or any 8v as the 16v engine has different spacing for the manifold i believe.
3. Daniel09 Established Member Joined: Jul 2009 N.wales! Posts: 1024 slammed VTS

   #3 7th August 2011, 10:11

   even if it did fit it would sit on a bad angle due to size of 16v engine head, compared to the smaller 8v
4. logy55 L-plater Joined: May 2010 Mirfield, Huddersfield Posts: 34 Silver mk2 vtr

   #4 7th August 2011, 11:45

   cheers boys, was curious and that saved me some time