lamba wires

  1. Established Member Joined: Dec 2009 near manchester Posts: 1190 vtr'd FURIO....
    #1
    Is it ok to extend the wires on the lamba sensor , on my 4 -2-1 manifold the plug is at the bottom instead if half way up .
  2. Regular Poster Joined: Nov 2010 alton hampshire Posts: 348 97 mk1 vtr 85 LR 90
    #2
    not ideal but if you do extend the loom not the sensor as the wire on the sensor is steel and wont solder and make sure you get a real good solder joint as they run a 1.5 volt signel and ity wont take much to mess the signel up
    i would sugest geting a lamber for a mk1 and cuting the little lug off the side of the plug
    hope this helps Tom