Enclosed induction fitment?

1. Saxo_Wilson Established Member Joined: May 2005 Newcastle (Cramlington) United Kingdom (England) Posts: 1268 Ice blue Saxo VTS

   #1 19th July 2006, 15:03

   Hey,
   
   I have just fitted an enclosed induction kit which i received today. Does the fitment look correct?
   
   Part of shield is touching the manifold heat shield (As showing in photo). I am worried it will melt, but it doesn’t want to budge from that position. Any tips?
   
   
   
   
   
   
2. ets2k9 Saxperience Post Whore Joined: May 2006 Hednesford, West Mids Posts: 6230 Seat Leon Cupra R

   #2 19th July 2006, 15:45

   Mine doesn't sit much better than that mate. I'm not sure what else you can do without buying a new pipe or silicone hoses.
3. SteVTR Saxperience Forum Bum Joined: Jun 2005 carlisle United Kingdom (England) Posts: 2934 106 GTi

   #3 19th July 2006, 17:32

   mine sits abit better than that because i dont have the egr valve anymore
   
   i have got an idea on how to get mine to fit abit better and be abit better attached when i get round to doing it i'll put some pics up
4. Saxo_Wilson Established Member Joined: May 2005 Newcastle (Cramlington) United Kingdom (England) Posts: 1268 Ice blue Saxo VTS

   #4 19th July 2006, 17:35

   Cheers mate.
   
   Was it hard to remove the valve and did it make any diffrence?
5. SteVTR Saxperience Forum Bum Joined: Jun 2005 carlisle United Kingdom (England) Posts: 2934 106 GTi

   #5 19th July 2006, 17:41

   dont think it makes any difference and i couldnt tell you how hard it is to remove as it was removed when i got the engine
6. Saxo_Wilson Established Member Joined: May 2005 Newcastle (Cramlington) United Kingdom (England) Posts: 1268 Ice blue Saxo VTS

   #6 19th July 2006, 18:34

   I have managed to lift the kit off the manifold heat shield. I have used a cable tie to lift it off the sheild.