106 3 plug main looms multiplug *pics and explanation added*

1. AlexBp West Midlands Joined: Dec 2007 West mids Posts: 23149 Supra,civic GL

   #1 3rd April 2012, 22:59

   right this is a weird (might seem obvious) question but i want to check
   
   on the main plug behind the headlight are all the wires straight 1 to 1 connections
   
   aka one wire going into it corresponds to the opposite wire coming out and doesnt have say one wire in powers 2 out the other side?
   i cant find a diagram for 3 plug in the haynes i have and im removing that plug to put my own in as my car only uses 6 wires out of it anyway so im wanting to just connect straight to the same 6 the other side after ive re routed it like
   
   just to get the car running with the loom routed where i want atm ill put a plug in at a later date
2. Sophia_Bush Saxperience Post Whore Joined: Jan 2007 Shropshire Posts: 9994 Moonstone Blue 106 GTi

   #2 3rd April 2012, 23:06

   ryanmt and tweeqd (grey ax vtr turbo) have diagrams for the 3 plug in general dude *edit*
3. AlexBp West Midlands Joined: Dec 2007 West mids Posts: 23149 Supra,civic GL

   #3 4th April 2012, 19:15

   dont need diagrams ect gav just need to know if they are just wired 1-1 and that the plugs dont have any crossed connections in them
4. AlexBp West Midlands Joined: Dec 2007 West mids Posts: 23149 Supra,civic GL

   #4 9th April 2012, 00:57

   right few pics to just show what im attempting to do for now
   
   i have labeled up each wire with the corresponding pin number on the plugs
   
   interior
   
   
   
   engine
   
   
   
   and ive listed the numbers used on both
   
   
   
   for a temp measure to route the loom and so i can get the rest of the loom finalised to length before i get my bulkhead connector i just want to connect the wires up
   
   if i just go 2-2 3-3 4-4 ect it should work yes??
5. Tom5190 Saxperience Post Whore Joined: Sep 2007 Someones Bumhole Posts: 5721 Mk2 16v Desire

   #5 9th April 2012, 01:26

   Yea that should work all of the conversions ive done ive not seen any bridged pins, pin to pin is correct. You could just buzz test across the plug when its plugged in to be 100% & for piece of mind.
6. AlexBp West Midlands Joined: Dec 2007 West mids Posts: 23149 Supra,civic GL

   #6 9th April 2012, 11:41

   thanks tom i didnt think there would be but i wanted to be sure
   im useless with electrics lol
   
   im going to do it wire by wire anyway plug in looms round the door and one by one cut and relocate the wires test firing each time to be sure