mk1 vtr clocks in 1.0

1. Wavey87 Newbie Joined: May 2012 Posts: 12

   #1 4th May 2012, 13:53

   Hi I'm looking at getting some mk1 vtr clocks for my 954cc ie 1.0 is it a staright swap wiring wise, although presumably the rev counter would need wiring up, how would i do this
   Regards David
2. user_20080 Saxperience Hardcore! Joined: Dec 2007 smurfland. Posts: 17346 Ex saxo owner.

   #2 4th May 2012, 18:05

   You have find the correct input on the ecu then run a wire to the clocks,might be easier & look better just to fit an aftermarket rev counter.
3. lewismonteith Frequent Poster Joined: Feb 2012 Portsmouth Posts: 568 1992 MX-5 1.6 SE

   #3 8th May 2012, 21:02

   There's a guide on here somewhere, you need to run the wire under the dash through the engine bay to the ECU, then split it to one of the wires in there. Try and find the guide, I used it and it works perfectly
4. lightining996 L-plater Joined: May 2012 Durham Posts: 97 106 quicksilver 1.4

   #4 9th May 2012, 22:09

   the white vtr clocks dont fit 1.0i-1.1i-1.4i- i have already tryed twice in my old 1.1 and i have just got the 1.4 vsx and they dont still dont fit the vtr has two cable blocks that go in the back the lower modles has 4 or 6 imputs in the bck