O-ring on ph2 oil filter housing.

20th October 2012, 15:38

Not the plastic screw in top, but on the aluminum housing that goes to the block. Does anyone know where to get the o-ring that goes in there?? mine isnt oil tight and it turns out its because it needs an o-ring it doesnt have i presume.

20th October 2012, 15:47

Any universal "o" ring will fit if its the same size. Why not convert it to the mk1 set up whilst you are there?

No "o" rings just the oil filter seal so cant go wrong really.

21st October 2012, 17:17

ive converted the car back. it ran a raceland 4/2/1 with the single sensor so in turn ran the cartridge but I now have a 4/1 to suit a phase2 so run a phase 2 setup that suits.
i did just that and threw a universal o ring in. not sure how well it will cope with heat as its just a cheap thing but ought to do fine.

30th November 2012, 10:44

going back to this, a universal o ring isnt deep enough.
sorted it a while back but forgot to mention. citroen do a special o ring, its deeper then a conventional one.