NSR wheel bearing

1. funkysax L-plater Joined: Dec 2012 Basingstoke Posts: 29 Saxo VTR 2003

   #1 31st December 2012, 10:48

   Hi all, got a slightly worn ns rear bearing. Can you peeps tell me EXACTLY what tools I need to change this please? Quite handy with the spanners, just never done this before. Confidence a bit low after failing to fix a Matiz. Stupid bloody Daewoos.
2. Lee_gsi Infrequent Poster Joined: Nov 2012 Havant (Hampshire) Posts: 181 Saxo Furio and Vauxhall Signum

   #2 31st December 2012, 18:40

   A big press I think as the bearings are in the rear drums
3. funkysax L-plater Joined: Dec 2012 Basingstoke Posts: 29 Saxo VTR 2003

   #3 3rd January 2013, 10:20

   Mine has dics on the back. Can the guru's. Please give me a copmprehensive list of the tools required for this job. I dont have many tools so i need the list before i can even start. Thanks.
4. funkysax L-plater Joined: Dec 2012 Basingstoke Posts: 29 Saxo VTR 2003

   #4 8th January 2013, 14:44

   Anyone? No haynes.
5. Ben_SaxoForte Saxperience Forum Bum Joined: Mar 2009 Stoke-on-trent Posts: 2640 Mk5 Golf GTTDI Mk2 VTR Project

   #5 14th January 2013, 23:42

   Socket & breaker bar to loosen the hub nut 30 or 32mm i think..
   3 leg puller to pull the inside race of the bearing from the stub pin.
   hammer to knock new hub gently onto the stub pin.
   
   Think thats about it if you change the whole hub & bearing assembly, obviously you need a jack and something to take off your wheel nuts and brake assembly too though.
6. chris-hall-yo Frequent Poster Joined: Sep 2011 Stratford-upon-avon Posts: 596 Saxo 1.1

   #6 15th January 2013, 19:46

   32mm i think and you can cut the race of from the stub pin with a grinder and chizel if your stuck for tools