Heater Control Switch/ Blower Switch

  1. #1
    Only have the full blast setting available on mine. Bought what i thought was the right part from ECP but turns out it wasn't. Anyone know where i can get a new one of these?
  2. #2
    It sounds like the resistor pack on the blower motor is faulty mate.Its easier to just get a good used blower motor.(same motor right across the saxo range)
  3. #3
    Hi there, is it worth just getting the resistor or am i better of getting the entire motor? Just weighing up the options.
    Brand new resistor vs used blower motor? About the same cost.
  4. #4
    Tbh only you can answer that one mate,just saves a bit of time not having to change over the resistor pack.
  5. #5
    Took the motor out and as per another thread i drilled out the fans rivets and soldered a wire across the thermo resistor. Fixed it! (Surprised face) just riveted it back up and fitted it. All done with an hour and a half and cost bugger all.


    Sent from my iPhone using Tapatalk
  6. #6
    Quote:
    Originally Posted by bubbaspaarx View Post
    Took the motor out and as per another thread i drilled out the fans rivets and soldered a wire across the thermo resistor. Fixed it! (Surprised face) just riveted it back up and fitted it. All done with an hour and a half and cost bugger all.


    Sent from my iPhone using Tapatalk
    The wire trick is an old 1 & is only a temporary fix.
  7. #7
    Fingers crossed it gets through the cold patch


    Sent from my iPhone using Tapatalk