Dastek Unichip A pin out?

23rd April 2013, 10:50

Hi guys,
bought a Dastek A for my budget turbo build, however it came with no loom (hence getting it for £35). Does anyone have a pin out diagram that can tell me what wire I should be replacing as to shorten the story, a 24 pin motherboard connector is the same as the Dastek just longer so i'm going to buy one, shorten it, then fit new wires for the Dastek to it (as you can buy them as a crimp connection set without wires fitted).

So basically I need a visual diagram that states what colour from what pin and what it does

Thanks everyone - i've gotten alot of advice so far

23rd April 2013, 11:08

how you going to adjust it to suit --you need the dastek dealer software

23rd April 2013, 11:26

Now i'm slightly confused, could you explain?

I thought all the A series dastek would have the same pins out, which then need to be connected to your loom, then it gets mapped to suit? I know i'll be needing to find a boost module too?

23rd April 2013, 19:18

I was just pointing out that you cannot map it yourself unless you have the software--who ever is going to map it will give you a wiring diagram
from mmeory we used to use the dastek b type --so check with mapper if its the right unit for your car

23rd April 2013, 20:09

Don't quote me on it but I think only b series and dastek a work on saxos?

23rd April 2013, 20:39

Dastek a wont work on a saxo, john is right a b unit or the q unit will

23rd April 2013, 21:01

Lol I missed q off my post

Edit no i didn't.. I hit a instead of q