as per title. It's on the branch off from the block for the oil filter. It's just snapped off as I am doing an oil change! Can I run it for 150 odd miles without it? Is it a big deal?
sensor near the oil filter on a vtr
-
#1
-
#2Sounds like the oil pressure switch mate.1 user thanked this post:
-
#3Its a big deal
-
#5Just means if your oil pressure drops or temp goes through the roof you won't get a light to tell you
-
#7Dear Kmak577,
I think you may also want to try and remove the broken part/s off your broken oil pressure switch aswell, if you havn,t already
You may need to remove the exhaust manifold in order to make access easier.
You may want to put a couple of drops of threadlock on the threads of your new oil pressure switch, and don,t over tighten it, and strip the threads.
I would advise that you don,t even start the engine until you have your new oil pressure switch fitted.
I hope this helps,
Vince, -
#8Tbh if that happened to me and I needed to use the car until i got the part.. I'd just drive it.
I bet you've done loads of miles.. Has it ever had a oil pressure problem? Didn't think so
.
-
#9Unless its low on oil, or you are driving it extremely hard, you don't need to worry
-
#10I've never ran either for years lol
