Driveshaft end sections? Removal?

  1. Saxperience Post Whore Joined: Jan 2008 ..... Posts: 5231 ..............
    #1
    Does anyone know how to remove driveshaft end joints? From shaft?

    The bit that connects shafts to cups?
    Hidden by cv joint?

    Regards?
  2. Saxperience Forum Bum Joined: Dec 2012 Perth Posts: 3665 Peugeot 106 1.1 Turbo Peugeot 106 1.5D Turbo Peuge
    #2
    Not sure what you mean?

    the CV joint itself is in the "cup".

    Why are you removing it?

    new universal boots stretch over the top. if you're changing the CV joint itself, you'll probably bugger it. far easier to get a new shaft.
  3. Saxperience Post Whore Joined: Sep 2007 Someones Bumhole Posts: 5721 Mk2 16v Desire
    #3
    They just knock off iirc on Saxo/106 there's a snap ring on the end of the shaft. If not then its a cir-clip type (PSA use both.) I usually change boots that way, stretchy universal ones never seem to last as long as OEM replacements.
  4. Saxperience Post Whore Joined: Jan 2008 ..... Posts: 5231 ..............
    #4
    The inside cv joint

    They end cup that goes through hub...

    Just hit it?
    It's from a saxo and I just need the end to fit to hubs so I can move the car around
  5. Saxperience Post Whore Joined: Sep 2007 Someones Bumhole Posts: 5721 Mk2 16v Desire
    #5
    I'm a bit confused mate the hubs are at the wheels. They are the outer joints? Do you mean the inner joint that goes through the bracket?
  6. Saxperience Post Whore Joined: Jan 2008 ..... Posts: 5231 ..............
    #6
    Yea I mean outer joints but inner joints of the cup itself.
    So I can use the cup in the hub...,
    ( sorry dude, on the phone and in a rush )
  7. Saxperience Post Whore Joined: Sep 2007 Someones Bumhole Posts: 5721 Mk2 16v Desire
    #7
    Ahhhh sorry I know what you mean. Ive not done it before however im sure the cups are heated then the inards are pressed in. No idea how you get them out maybe heat and stivk someweld onto the inner section and use a slide hammer