Exhaust gasket

1. lewismonteith Frequent Poster Joined: Feb 2012 Portsmouth Posts: 568 1992 MX-5 1.6 SE

   #1 18th October 2013, 15:47

   I have a mk2 VTR with a mk2 VTS centre section. I can't seem to find a sealing ring that fits properly, the VTR one is too small to fit on the centre section and the VTS one is too big for the manifold.
   
   Is there one that fits both?
2. Bedford126 Saxperience Post Whore Joined: Jul 2010 Morley, Leeds Posts: 8469 Civic ep3 type r powered by TDI NORTH

   #2 18th October 2013, 16:42

   Measure the flange with a micrometer (cheap set from wilco will do) and then take the measurements to the local motor factors.
   
   I'm guessing you are after the compressed wire fire gasket?
3. lewismonteith Frequent Poster Joined: Feb 2012 Portsmouth Posts: 568 1992 MX-5 1.6 SE

   #3 18th October 2013, 16:56

   From researching the VTS bore is 50mm and the VTR is 46.5mm or something like that, surely someone's done this before?
   
   
   Sent from my iPhone 5 using Tapatalk 2