standalone ECU loom help :)

1. AzzAW93 Frequent Poster Joined: May 2010 worcester Posts: 703 peugeot 106 VTR

   #1 4th December 2013, 19:38

   right basically what do i need to do/ who do i need to contact regarding ECU looms and so on
   
   at the moment i have the original 1.1 interior loom and engine loom with a VTR unlocked ecu.
   my plans are to run a tu5j4 engine with omex ecu and loom. so what do i need to buy?
   will i need a tu5j4 engine loom to use the connectors?
   will my interior loom be fine as it is?
   and all other dumb ass questions related
   
   need as much info as possible on this one so fire away(preferably from people with experience)
   
   azza
2. KierenCrawford Banned Joined: Nov 2013 Posts: 411

   #2 4th December 2013, 19:59

   You'll need the 16valve loom for the engine connectors, then I'm not sure how they do it but you'll either splice your ecu side to the omex loom or there may be someone that makes connectors pre sliced so you can plug it straight in with messing about with the wiring, I haven't done it but that's just what makes sense to me and will get the ball rolling, insure someone will be along some time soon to correct me where I'm wrong, and point you in the wright direction...
   Good luck fella

   1 user thanked this post: AzzAW93
3. AzzAW93 Frequent Poster Joined: May 2010 worcester Posts: 703 peugeot 106 VTR

   #3 5th December 2013, 19:36

   Anyone else willing to share some info?
   Azza
4. user_39740 Established Member Joined: Dec 2009 near manchester Posts: 1190 vtr'd FURIO....

   #4 5th December 2013, 20:10

   if this is for the car pictured in your avatar , just pm sandy309 he could make you a full new loom up ?

   1 user thanked this post: luthor1
5. da1gingertiger L-plater Joined: Feb 2012 Posts: 61

   #5 7th December 2013, 06:11

   U need omex 600 with loom to fit that engine then will just be plug and play leave standard looms as they are and leave ecu plugged in for clocks to work you can take out engine harness bt you have got to leave wiring for alternator and speedo if you have vtr clocks with rpm clock u need to wire that to omex there a guide on here for that
6. user_10176 Saxperience Post Whore Joined: Jun 2006 Ramsey st marys, peterborough Posts: 8288 Saxo's, Corsa (Daily)

   #6 7th December 2013, 07:13

   Or pm the lads at Beaniesport, mike will and can make looms for everything.

   1 user thanked this post: user_7
7. PSILOS L-plater Joined: Nov 2013 Lamia Posts: 56 Saxo vts 16v

   #7 7th December 2013, 10:08

   take the omex 600 and a loom from tu5