Stuck centre section

1. Saxovch22 Established Member Joined: Feb 2011 Scotland Posts: 1191 02 Saxo Vts

   #1 18th December 2013, 21:34

   Basically got a supersprint centre section in my room that
   Was off my old vtr and it's in good condition.
   
   I was going to buy a kam racing centre section for my vts
   but could save money and use the supersprint but I have a problem...
   When I removed it I tried to part the 2 bits to make it easier to sell but only managed to seperate it a few inches now I'm struggling to get the 2 bits together perfectly again!
   
   Any tips ? I've used wd40 and brute strength
   
   May end up taking it to a garage see if they can do something
2. Spanky Saxperience Post Whore Joined: Dec 2007 Newcastle Upon Tyne Posts: 9578 Saxo VTS

   #2 18th December 2013, 22:04

   Hammer?
3. user_53022 Newbie Joined: Jun 2011 Posts: 26

   #3 18th December 2013, 22:08

   This happened me also. Put one end up up against a wall and put a bit of timber over the other end then hit it a few times with a lump hammer job done.
4. user_24390 Saxperience Post Whore Joined: Jun 2008 North Wales Posts: 5576 Fabia VRS PD130/ VTR Mk2

   #4 18th December 2013, 23:08

   Give it a clean on the inside with a bit of emery paper or a dremel. Probably just a bit of rust build up stopping it going in properly.
5. Manu Saxperience Addict Joined: Dec 2009 Posts: 11714 A6 Le Mans tuned/A3 TFSI tuned

   #5 19th December 2013, 07:32

   heat gun, it will give in eventually
6. user_20080 Saxperience Hardcore! Joined: Dec 2007 smurfland. Posts: 17346 Ex saxo owner.

   #6 19th December 2013, 18:56

   Place it in a vice gently heat up with a blow lamp,the tap with a hammer.