Lambda sensor wires VTR

1. chrisvtr2 Newbie Joined: Jul 2013 Posts: 20

   #1 23rd December 2013, 22:25

   I have put a phase 1 decat 421 manifold on my phase 2 saxo vtr, the lambda sensor hole is now at the bottom of the engine and the wire wouldn't reach so I cut the wires so I could extend the wires but now I have forgot witch wire goes where, there is a grey wire a black wire obviously grey to grey black to black but there is two white wires witch 1 goes to witch 1 please help
2. P-I-Staker Newbie Joined: Nov 2012 Posts: 23 Peugeot 106 Quicksilver, Citroen Saxo VTS MK2

   #2 24th December 2013, 01:58

   Although it doesn't help you now you should have been able to pull the tape/plastic wrap off the original wiring to separate it from the loom further up and then feed it down the back of the gearbox.
   
   I believe both white wires are for the heater and it doesn't matter which way round they're connected but any fires or death are not my responsibility.
3. chrisvtr2 Newbie Joined: Jul 2013 Posts: 20

   #3 24th December 2013, 14:16

   Lol ye I should of done that in the first place but I was impatient ye knowing my look it would set of fire 😊 I'll just check what you have said as I didn't no any way so I might be a set closer thank you
4. user_61517 Frequent Poster Joined: Sep 2012 canterbury Posts: 586 3/4 vtr turbo

   #4 24th December 2013, 14:44

   one white wire is an earth. the other should have 12v when started,
   
   Not sure what way they go round mind you.
5. chrisvtr2 Newbie Joined: Jul 2013 Posts: 20

   #5 24th December 2013, 16:05

   We'll if so I don't want them the wrong way round lol