Removing Lambda Sensors

1. Choppa7 L-plater Joined: Feb 2009 Posts: 95

   #1 17th February 2014, 21:57

   Any tricks other than a good soak in wd40 and a decent wrench?
2. Ali123 Saxperience Forum Bum Joined: May 2011 huddersfield Posts: 2635 ph3'd c2 gt

   #2 17th February 2014, 22:05

   a blow torch!
3. jones91 Established Member Joined: Jun 2011 Bridgnorth (Shropshire) Posts: 2001 Jdm Dc2 Integra

   #3 18th February 2014, 08:33

   If you've got the room then a spanner and a hammer
4. lewismonteith Frequent Poster Joined: Feb 2012 Portsmouth Posts: 568 1992 MX-5 1.6 SE

   #4 18th February 2014, 09:08

   Rev the shit out of the car to get the exhaust hot, sorted
5. Choppa7 L-plater Joined: Feb 2009 Posts: 95

   #5 18th February 2014, 09:18

   Quote:

   Originally Posted by lewismonteith Rev the shit out of the car to get the exhaust hot, sorted

   It wont now that its on the garage floor!
   
   Blowtorch it might have to be then!
6. Assenracing Infrequent Poster Joined: Aug 2012 Wirral Posts: 185 E46 330d - Saxo Vts

   #6 18th February 2014, 09:27

   As said get some heat on it and a good ring spanner
7. Choppa7 L-plater Joined: Feb 2009 Posts: 95

   #7 18th February 2014, 09:57

   Stilson was my preference tbh, wouldnt shift without heat so I'll get the candles lit at some point this week
   
   Cheers
8. user_20080 Saxperience Hardcore! Joined: Dec 2007 smurfland. Posts: 17346 Ex saxo owner.

   #8 18th February 2014, 12:08

   Plus gas dismantling spray,wire brush blow torch.Then put a ring spanner & hit the spanner with a hammer.Helps if you use a long spanner.
9. smiith Saxperience Hardcore! Joined: Sep 2007 Jail - Whitby Posts: 15034 520bhp Honda Jazz

   #9 18th February 2014, 16:09

   See if you can find a scaffolding pole, put that on the spanner and make it a mile longer!