Easiest way to refit mk2 rocker cover? *help needed ASAP*

1. DarylVTR Saxperience Post Whore Joined: Mar 2006 United Kingdom (England) Posts: 6802

   #1 4th September 2006, 21:55

   Trying to put the rocker cover back on and its a tight fit, the injector rail gets in the way, so my question is, whats the easiest way to fit the rocker cover back on? Do i need to remove anything to make it go on easier?
   
   It seems really hard to get on at the moment without knocking the spacers or splash tray out of place
   
   
   any help welcome.
   
   
   Cheers
2. hesslevtr Saxperience Hardcore! Joined: May 2004 Hull (England) Posts: 18709 1.6 vtr

   #2 4th September 2006, 21:59

   the injector rail dont you mean coil pack
   
   just undo the 3 10mm bolts and lift off put rocker cover on then put coil pack on
3. DarylVTR Saxperience Post Whore Joined: Mar 2006 United Kingdom (England) Posts: 6802

   #3 4th September 2006, 22:01

   is it just 3 10mm bolts to take the coil pack off?
   
   The bolts looked as if they were on a fixed bracket
4. hesslevtr Saxperience Hardcore! Joined: May 2004 Hull (England) Posts: 18709 1.6 vtr

   #4 4th September 2006, 22:09

   yeah just the 3 2 on 1 side 1 on other
5. DarylVTR Saxperience Post Whore Joined: Mar 2006 United Kingdom (England) Posts: 6802

   #5 4th September 2006, 22:18

   awsome and then it just lifts off? i know 1 side has a electrical block on bolted down and then 2 bolts to fully remove it, might be easier than triying to wedge it in the small gap