Seatbelts fully retracted

  1. #1
    So my car was stripped and then I decided to put it all back in, however when I came to fit the rear seatbelts they had fully retracted and won't unravel. Is there a way to release them? Thank you
  2. #2
    This happened to mine, weirdly if you bolt them back in their original place and then try to pull the strap out slowly, that should do the trick. I think they have to be in that position for the ball bearing or whatever it is inside to work
  3. #3
    I read that somewhere else, I bolted them back into the car but still nothing :/ I'll give it another go though, cheers
  4. #4
    Remove the black cap on the side. The one WITHOUT the spring coil inside, your be able to feel which one has the coil inside.

    With the black cap removed your be able to see the ball bearing, remove it, pull the seatbelt out, tie a knot in the belt and then put the ball bearing back in.
    1 user thanked this post:
  5. #5
    Quote:
    Originally Posted by MPHZONE View Post
    I read that somewhere else, I bolted them back into the car but still nothing :/ I'll give it another go though, cheers
    They are side specific, so if they don't work the one side, swap them over.
    1 user thanked this post:
  6. #6
    Quote:
    Originally Posted by SGregg View Post
    They are side specific, so if they don't work the one side, swap them over.
    this.. ^
    1 user thanked this post:
  7. #7
    Cheers everyone! Next time I get a minute spare I'll give it another go