Important! : Clutch problems advise and other bits needed

23rd October 2014, 22:05

So not 100% sure if my clutch is on its way out but finding it hard to push into some gears now and again not all the time. And sometimes when trying to put into 5th it will go into 3rd.

Is this clutch? as already changed the nylon ball, gear selector linkage however not changed the selector bar or gear knob box with the bar that goes to the selector bar..

Gears seem to change normal more than often but the odd time it sticks. Gear changing is with peddle about 1/4 from pressing fully in so under half way no high revs and can have in gear holding on slope.

Any advise or recommendation on what this could be if is all the above that's fooked then what would a good after market set be worth getting hold of and if uprated clutch would timing also have to be changed and done too.

Thanks in advance.

24th October 2014, 09:24

If you are trying to select 5th and you get 3rd gear this sugests a problem with the gear linkages.

25th October 2014, 02:03

Quote:

Originally Posted by oxass

If you are trying to select 5th and you get 3rd gear this sugests a problem with the gear linkages.

gear linkage was changed to quicksilvers from standard as they where bent and warn out. Checked over them and the run though gears fine just the odd time it happens. Might just be me driving or could be something else as not fully clued up on stuff like this.