Any idea...

8th October 2016, 08:01

Anybody have any idea of how to get this bolt out as it's not ment to be there and it's in pretty tight so any ideas would be a lot of help, thanks in advance.

Sent from my SM-G920F using Tapatalk

8th October 2016, 10:05

Why do you want it out is there play in the arm? Try to undo it but it may have just been wedged in with a hammer.. Try tapping it out from the threaded end you should probably use a drift or something if you do that though so you don't mushroom the end

8th October 2016, 13:30

Quote:

Originally Posted by Ben_SaxoForte

Why do you want it out is there play in the arm? Try to undo it but it may have just been wedged in with a hammer.. Try tapping it out from the threaded end you should probably use a drift or something if you do that though so you don't mushroom the end

Thanks Yea 1st is a bugger to get into most of the time but not all the time sometimes it's okay but not very often do you think it's the bolt in it I think it is, is there ment to be any play in it? From where the shaft is there's play up and down towards the shafts if that makes sense? It's ment to have something els3 not a bolt there right?

Sent from my SM-G920F using Tapatalk

8th October 2016, 13:40

I'd say it normal for a very small amount of play but if your getting a lot then there must be some wear there, originally they have a solid metal pin which goes through the arm but these work loose overtime and fall out and are usually replaced with a roll pin which you can pick up from Citroen for about 30p so if you can get the bolt out it may be worth trying that but they may have damaged the arm by putting the bolt though in which case you might end up needing the gearbox off to get proper access to properly repair it.

8th October 2016, 19:43

I have a nice bag of roll pins if you need one. Worth trying with new. However if theirs been lot of play and wiggle hence why bolt been put though to make solid again.

Judging by the size of that bolt going though new roll pin is going to be a close size I could be wrong but just had a look at the pins seems roughly about same size. Hard to tell without matching side by side.

You can tap it though easy enough if you got right tools and extinction bars and tap though.

If you want one of the pins pm me with details ill get you one sent in post for ya

Ebay listing from £3 then postage on top lmfao.

Ill do for what ever it costs for postage to be covered. So whatever postage is think £0.50 or so then yours.

Refund of any difference if change left over from postage