Bm baker linkages and quickshift ??

1. gti180craig Regular Poster Joined: Jan 2008 Birmingham Posts: 458 Saxo vtr turbo

   #1 30th April 2017, 16:52

   Right I dunno if it's just me being stupid or its because I'm tired I went to fit these parts today and they have stumped me how do the linkages fit I have popped mine off but these seem to be male ends and I need female ones that push on the ball also the quick shifter it self where is that supposed to go as the place where I thought it fitted is to small to fit over the end any ideas. Here is what I have
   
   
   
   
   
   Cheers guys
2. Bedford126 Saxperience Post Whore Joined: Jul 2010 Morley, Leeds Posts: 8469 Civic ep3 type r powered by TDI NORTH

   #2 30th April 2017, 17:57

   Undo the little spring clip and pull it out. The ball joint with the thread on will then pull out with pliers. Fit them on your car and refit the spring clip, job done.
   
   http://www.bakerbm.com/106.php?data=quickshift106 And fitting instructions

   1 user thanked this post: gti180craig
3. gti180craig Regular Poster Joined: Jan 2008 Birmingham Posts: 458 Saxo vtr turbo

   #3 30th April 2017, 18:02

   Awesome mate cheers for that what about the quick shift where does that fit onto ??
4. gti180craig Regular Poster Joined: Jan 2008 Birmingham Posts: 458 Saxo vtr turbo

   #4 30th April 2017, 20:20

   All fitted cheers Bedford it's a huge improvement
5. user_98505 Regular Poster Joined: Sep 2015 Posts: 269 106 Rallye

   #5 3rd May 2017, 12:45

   Never seen linkages with the screw in balls attached before. How would you go about fitting those? Are the old OEM balls that the rods attach to removeable?
6. Bedford126 Saxperience Post Whore Joined: Jul 2010 Morley, Leeds Posts: 8469 Civic ep3 type r powered by TDI NORTH

   #6 3rd May 2017, 15:42

   Nope they are pressed in, you are supposed to grind the tops off then the old one hammers out then put the screw through and a nylon nut, not much point to be honest.