Important! : Ignition wire?

6th August 2018, 18:33

I want to install a Power builder (Bee-R)

i have connected everything (Live, earth, RPM and ignition)

Here a couple photo's for info:
Wiring layout from the unit

Wiring diagram from ignition connector, from left top to bottom right
N4 goes to a suppresor according to the wiring diagram
N3 goes to the fuel injection main relay
N2 earth to fuel ECU
N1 earth to fuel ECU
[img]https://i.gyazo.com/3e32d40a2dc0da585720917020de4d69.png/img]

so here is what goes wrong, i connected the RPM wire to a RPM signal wire (LED on unit blinks when i rev to that RPM so 100% sure that works.) Connected the green wire from the bee-r unit to N1 and/or N2 of the ignition plug, no result, LED lights up op on the selecter RPM but no ignition cut.

Also connected the green wire from the unit to N3 of the connector plug, same again, LED lights up on the selected RPM but no ignition cut.

My question is simple, where should i connected my green wire from the unit?

6th August 2018, 18:34

Edit: mis type on the second image, here is the correct image

6th August 2018, 18:34

Another mistake has been made, hate it i cant edit my post....

here again the right picture,

[img]https://i.gyazo.com/0aa507794ceab97b62834bccbcc07cd4.jpg[/img[

6th August 2018, 18:35

8th August 2018, 22:08

And you trust a product from someone who can't even spell 'Grey' correctly?
:-D

12th August 2018, 12:13

Quote:

Originally Posted by Chipwizards

And you trust a product from someone who can't even spell 'Grey' correctly?
:-D

haha didn't even noticed that! you my friend are very sharp. well i haven't installed it.