mk1 spoiler

9th October 2006, 22:46

I have a saxo mk2 but I'm thinking of removing the spoiler and fitting an mk1 spoiler. I know it should be bolted and bonded on, but if I were to just use bond would it hold it?

9th October 2006, 23:00

hey m8 i have a mk2 with a mk1 spoiler, didnt bond it, bolted it threw my tailgate, and stuck rubber gromits in the exsiting spoiler holes in the glass!!

9th October 2006, 23:04

I know bolting would be the best option but I wanted to try and avoid this, I drilled holes on my previous car for a spoiler and it took a lot of time and effort as I don't have the best tools for the job... Would be a lot easier if I could just bond it on.

9th October 2006, 23:14

i must say it is a pain in the ass, not to bad makin the holes its getting your tools in. bonding it on aint to bad but its more lyable to theft

9th October 2006, 23:21

Good point, I never thought about theft. I was thinking about it just falling off! I'm watching ebay just now for a spoiler the same colour as my car so once I get it I'll decide what I'm going to do.

10th October 2006, 23:25

Just a thought, if I'm only bonding the spoiler on what do I use to hold it in place while it's bonding? Would tape be enough or do I need some sort of clamps or what?

11th October 2006, 00:34

stand there holding it for a few hours lol.

11th October 2006, 21:37